Table of Contents
Advertisement
Configuring RSVP (NSM Procedure)
Copyright © 2010, Juniper Networks, Inc.
Table 199: Router Discovery Configuration Details (continued)
Task
Configure physical
interfaces.
Specify tracing options.
To configure the Resource ReSerVation Protocol (RSVP) in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Protocols.
3.
Select RSVP.
4.
Add or modify settings as specified in Table 200 on page 352.
5.
Click one:
6.
Your Action
1.
Click Interface next to Router Discovery.
2. In the Name box, enter the name of the interface.
3. In the Comment box, enter the comment.
4. In the Name box, enter the name of an interface.
5. In the Comment box, enter the comment.
6. From the Max Advertisement Interval list, select the maximum
interval between each router advertisement message.
Range: 4 through 1800 seconds
Default: 600 seconds
7. From the Min Advertisement Interval list, select the minimum
interval between each router advertisement message.
Range: 3 seconds through 1800 seconds
Default: 400 seconds
8. From the Lifetime list, select the lifetime value.
1.
Click Traceoptions next to Router Discovery.
2. In the Comment box, enter the comment for the traceoptions.
3. Click File next to Traceoptions.
4. In the Comment box, enter the comment for the filename.
5. In the Filename box, enter the name of the file to receive the
output of the tracing operation.
6. In the Size box, enter the maximum trace file size.
7. From the Files list, select the maximum number of trace files.
8. Select one of the following:
no-world-readable—To restrict the file access to owner.
world-readable—To enable unrestricted access.
9. Click Flag next to Traceoptions.
10. Click Add new entry next to Flag.
11. From the Name list, select the flag to perform the trace
operation.
12. In the Comment box, enter the comment for the flag.
13. Select the corresponding modifier for the tracing flag.
Chapter 20: Configuring Protocols
351
Advertisement
Table of Contents
