Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual page 144

M-series and MX-series Devices
108
Table 49: Lcc Configuration Details (continued)
Task
Configures aggregate port,
maximum queues per
interface and port-mirroring
instances for the PICs.
Enable a service package on
adaptive services interfaces.
Configure channelized E1
port and channel
specifications.
Your Action
1. Click Add new entry next to Fpc.
2. Click Pic next to fpc.
3. Click Add new entry next to PIC.
4. From the Name list, select the slot number of the DPC.
5. In the Comment box, enter the comment.
6. From the Framing list, select the framing type.
7. From the Vtmapping list, select one of the virtual tributary
mapping.
klm—KLM standard.
itu-t—International Telephony Union standard.
8. Select the No Concatenate check box to not concatenate
(multiplex) the output of a SONET/SDH PIC (an interface with
a name so-fpc/pic/port).
9. Select the Aggregate Ports check box if you want to aggregate
multiple ports on a PIC as a single port.
10. Select the Sparse Dlcis check box to support a full data-link
connection identifier (DLCI) range (1 through 1022).
11. From the Mlfr Uni Nni Bundles list, select the number of
multilink frame relay user-to-network interface
network-to-network interface (UNI-NNI) (FRF.16) bundles to
allocate on a Link Services PIC.
Range: 1 through 255
12. From the Max Queues Per Interface list, select the required
egress queues on IQ interfaces.
1. Click Add new entry next to Fpc.
2. Click Pic next to fpc.
3. Click Add new entry next to Pic.
4. Click Adaptive Services next to pic.
5. Choose Adaptive Services to enable a service package on
adaptive services interfaces.
1. Click Add new entry next to Fpc.
2. Click Pic next to fpc.
3. Click Add new entry next to pic.
4. Click Ce1 next to pic.
5. In the Comment box, enter the comment.
6. Click E1 next to Ce1.
7. Click Add new entry next to E1.
8. From the Name list, select the port number.
9. In the Comment box, enter the comment.
10. Click Channel Group next to e1.
11. Click Add new entry next to Channel Group.
12. From the Name list, select the channel number.
13. In the Comment box, enter the comment.
14. In the Timeslots box, enter the actual time slot number.
Copyright © 2010, Juniper Networks, Inc.