Configuring Routing Table Groups (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

Table 215: Rib Fields (continued)
Option
Multipath
Static

Configuring Routing Table Groups (NSM Procedure)

Copyright © 2010, Juniper Networks, Inc.
Function
Enables you to configure the multipath
option in the routing table for load
sharing between external BGP and
internal BGP.
Enables you to configure static routes to
be installed in the routing table.
You can group together one or more routing tables to form a routing table (RIB) group.
Within a group, a routing protocol can import routes into all the routing tables in the group
and can export routes from a single routing table. Each routing table group contains one
or more routing tables that the JUNOS software uses when importing routes. In the same
way, each routing table group optionally contains one routing table that the JUNOS
software uses when exporting routes to the routing protocols. You can also specify the
import and the export route tables and the import policies for the routing table group.
To configure routing table groups in NSM:
In the navigation tree, select
1.
In the list, double-click the device to select it.
2. Devices
Click the
Configuration
3.
In the configuration tree, expand
4.
Select .
Rib Groups
5.
Add or modify the parameters as specified in Table 216 on page 384.
6.
Click one:
7.
OK—To save the changes.
Cancel—To cancel the modifications.
Apply—To apply the routing option settings.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See the Updating
Devices section in the Network and Security Manager Administration Guide for
more information.
Your Action
1.
2. Enter the multipath options.
1.
2. Enter the global static route in
Device Manager > Devices
tab.
.
Routing Options
Chapter 21: Configuring Routing Options
Expand the tree and select
Rib
.
Multipath
Expand the tree and select
Rib
Defaults and destination address of
the static route in Route .
.
.
Static
383