Table 218: Static Fields - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices

Table 218: Static Fields

Option
Comment
Rib Group
Defaults
Route
386
Click the
3. Configuration
In the configuration tree, expand
4.
Select .
5. Static
Add or modify the parameters as specified in Table 218 on page 386.
6.
Click one:
7.
OK—To save the changes.
Cancel—To cancel the modifications.
Apply—To apply the routing option settings.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See the Updating
Devices section in the Network and Security Manager Administration Guide for
more information.
Function
Specifies the comment for the static
route.
Specifies the routing table group name
for which the static route is configured.
Enables you to configure the global
static route options. These options only
set the global defaults and apply to all
the configured static routes.
Enables you to configure the individual
static routes options. These options
apply to the individual destination only
and override any options configured in
the section.
Defaults
tab.
.
Routing Options
Your Action
Enter the comment.
Enter the name.
1.
2. Enter the default route to the
1.
2. Enter the individual route.
Expand the tree and select
Static
.
Defaults
destination address.
Expand the tree and select
Static
.
Route
Copyright © 2010, Juniper Networks, Inc.