Configuring Radius Server (Nsm Procedure); Table 347: Radius Option Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

Table 347: Radius Option Configuration Details

Option
Comment
Nas Ip Address
Related
Documentation

Configuring RADIUS Server (NSM Procedure)

Copyright © 2010, Juniper Networks, Inc.
Select a password protocol in the Radius Options workspace that specifies the
5.
password protocol used in the RADIUS packets.
Add or modify settings as specified in the Table 347 on page 557.
6.
Click one:
7.
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the radius option settings.
Function
Supplies a descriptive comment of the attributes.
Specifies the value of NAS-IP address in outgoing RADIUS
packets.
Configuring Ports (NSM Procedure) on page 555
Configuring PIC Console Authentication (NSM Procedure) on page 555
Configuring a Name Server (NSM Procedure) on page 554
A Remote Authentication Dial-In User Service (RADIUS) server is a type of server that
allows you to centralize authentication and accounting for remote users.
To configure a RADIUS server:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab. Then double-click the device for which you want to configure
2.
the RADIUS server.
Click the Configuration tab. In the configuration tree, select System > Radius Server.
3.
Add or modify settings as specified in the Table 348 on page 558.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the RADIUS server settings.
Chapter 25: Configuring System
Your Action
Enter a comment.
Enter the NAS-IP address.
557