Table of Contents
Advertisement
Copyright © 2010, Juniper Networks, Inc.
Table 273: NAT Configuration Details
Task
Enable multicast filters on
Ethernet interfaces when
IPv6 NAT is used for
neighbor discovery.
Specify the NAT name and
properties.
Configure the NAT pool
address range.
Configure Packet gateway
Control Protocol (PGCP).
Your Action
1.
Click Ipv6 Multicast Interfaces next to Nat.
2. Click Add new entry next to Ipv6 Multicast Interfaces.
3. From the Name list, select All to enable filters on all interfaces.
4. Select Interface name to enable filters on a specific interface
only.
5. In the Comment box, enter the comment.
6. Select the Disable check box to disable filters on the specified
interfaces.
1.
Click Pool next to Nat.
2. Click Add new entry next to Pool.
3. In the Name box, enter the identifier for the Nat address pool.
4. In the Comment box, enter the comment.
5. Expand pool.
6. Click Address next to pool.
7. Click Add new entry next to Address.
8. In the Name box, enter an IPv4 or IPv6 prefix value.
9. In the Comment box, enter the comment.
1.
Click Address Range next to pool.
2. Click Add new entry next to Address Range.
3. In the Low box, enter the lower boundary for the IPv4 or IPv6
address range.
4. In the High box, enter the upper boundary for the IPv4 or IPv6
address range.
5. In the Comment box, enter the comment.
1.
Click Pgcp next to pool.
2. In the Comment box, enter the comment.
3. Click the Remotely Controlled check box to configure the
addresses and ports in a NAT pool to be remotely controlled
by the gateway controller.
4. From the Ports Per Session list, select the number of ports to
be enabled.
NOTE: The ports per session should be either 2 or 4.
5. Expand Pgcp.
6. Click Hint next to Pgcp.
7. Click Add new entry next to Hint.
8. In the dialog box, enter an alphanumeric string of up to 3
characters that the BGF uses to match with a termination hint
located in the Direction field of a nonstandard termination ID.
Chapter 23: Configuring Services
461
Advertisement
Table of Contents
