Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual page 348

M-series and MX-series Devices
312
Table 165: Oam Configuration Details (continued)
Task
Configure LSP tracing options.
Configuring the Egress Router Address for LSPs (NSM Procedure)
When configuring an LSP, you must specify the address of the egress router by using the
To option.
To configure the egress router of a dynamic LSP in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Protocols > Mpls.
3.
Select Label Switched Path.
4.
Add or modify settings as specified in Table 166 on page 313.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Your Action
1. Click Traceoptions next to Oam.
2. In the Comment box, enter the comment.
3. Select the No Remote Trace check box to disable remote
tracing globally or for a specific tracing operation.
4. Click File next to Traceoptions.
5. In the Filename box, enter the name of the file to receive the
output of the tracing operation.
6. In the Size box, enter the maximum size of each trace file, in
kilobytes (KB), megabytes (MB), or gigabytes (GB).
7. From the Files list, select the maximum number of trace files.
Range: 2 through 1000
8. Select one of the following:
world-readable—To enable unrestricted file access.
no-world-readable—To restrict file access to owner.
9. In the Match box, enter the regular expression.
10. Click Flag next to Traceoptions.
11. Click Add new entry next to Flag
12. From the Name list, select the flag.
13. In the Comment box, enter the comment.
Copyright © 2010, Juniper Networks, Inc.