Configuring A Routing Policy Statement (Nsm Procedure); Table 130: Configuring Policy Statement Fields - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

Configuring a Routing Policy Statement (NSM Procedure)

Table 130: Configuring Policy Statement Fields

Option
Name
Comment
Copyright © 2010, Juniper Networks, Inc.
You can configure policy statements for routing policies. Each policy statement is
composed of from criteria, to criteria and then criteria. The from and to criteria comprise
a set of match conditions for the routing policy. The then criteria specify the action to be
taken when the from and to criteria are matched and when they are not matched.
To configure a routing policy statement in NSM :
In the navigation tree, select
1.
In the list, double-click the device to select it.
Devices
2.
Click the Configuration
3.
In the configuration tree, expand
4.
Select Policy statement
5.
Add/Modify the parameters as specified in Table 130 on page 249.
6.
Click one:
7.
OK—To save the changes.
Cancel—To cancel the modifications.
Apply — To apply the protocol settings.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See the Updating
Devices section in the Network and Security Manager Administration Guide for
more information.
Function
Specifies the name of the policy
statement.
Specifies the comment for the policy
statement.
Device Manager > Devices
tab.
.
Policy Options
.
Your Action
1.
2. Select
3. Specify the name.
1.
2. Select
3. Specify the comment.
Chapter 19: Configuring Policy Options
.
Click the New button or select a
policy statement and click Edit
button.
policy-statement .
Click the New button or select a
policy statement and click Edit
button.
.
policy-statement
249