Configuring Traceoptions (Nsm Procedure); Configuring File Options (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

Table 307: Interface Configuration Details (continued)
Option Function
Session Expiry Specifies the timeout period before session
expiration..

Configuring Traceoptions (NSM Procedure)

Copyright © 2010, Juniper Networks, Inc.
The traceoptions feature allows you to configure file and flag options.
To configure traceoptions:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure traceoptions.
Click the Configuration tab. In the configuration tree, select Services > Captive Portal
3.
> Traceoptions.
Enter a comment in the traceoptions workspace that describes the traceoptions.
4.
Click one:
5.
OK — Saves the changes.
Cancel — Cancels the modifications.
Apply—Applies the traceoptions settings.
You can now configure the following options:
Configuring File Options (NSM Procedure) on page 503
Configuring Flag Options (NSM Procedure) on page 504

Configuring File Options (NSM Procedure)

To configure file options:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure file options.
Click the Configuration tab. In the configuration tree, select Services > Captive Portal
3.
> Traceoptions > File.
Configure the file options as specified in Table 308 on page 504.
4.
Click one:
5.
OK — Saves the changes.
Cancel — Cancels the modifications.
Apply—Applies the file settings.
Chapter 23: Configuring Services
Your Action
Set the session expiration period. Range: 1
through 65535.
503