Configuring H248 Options Properties (Nsm Procedure); Configuring H248 Options (Nsm Procedure); Table 277: Graceful Restart Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices

Configuring H248 Options Properties (NSM Procedure)

468

Table 277: Graceful Restart Configuration Details

Task
Configure graceful restart
properties.
You can configure properties for the H.248 options. See the following topics:
Configuring H248 Options (NSM Procedure) on page 468
Changing Encoding Defaults (NSM Procedure) on page 469
Configuring Service Change (NSM Procedure) on page 469

Configuring H248 Options (NSM Procedure)

You can configure options that affect virtual BGF H.248 behavior.
To configure H248 options in NSM:
In the navigation tree select Device Manager > Devices.
1.
In the Devices list, double-click the device to select it.
2.
In the Configuration tab, expand Services > Pgcp.
3.
Select Gateway.
4.
Add or modify the settings as specified in Table 278 on page 469.
5.
Click one:
6.
OK—To save the changes.
Cancel—To cancel the modifications.
Your Action
1. Click Add new entry next to Gateway.
2. Click Graceful Restart next to gateway.
3. In the Comment box, enter the comment.
4. From the Maximum Synchronization Time list, select the
maximum time allowed for the synchronization procedure
with the PIC or DPC.
Range: 0 through 300
5. From the Maximum Synchronization Mismatches list, select
the maximum number of mismatches allowed during the
synchronization procedure with the PIC or DPC.
Range: 0 through 20000
6. Select the No Synchronization check box to disable the
synchronization procedure with the PIC.
Copyright © 2010, Juniper Networks, Inc.