Table of Contents
Advertisement
Configuring Filters for inet Family Type (NSM Procedure)
Configuring Firewall Filter for inet Family Type (NSM Procedure)
Copyright © 2010, Juniper Networks, Inc.
You can configure filters, prefix-actions, service filters, and simple filters for Inet using
the following options. See the following topics:
Configuring Firewall Filter for inet Family Type (NSM Procedure) on page 167
Configuring Prefix-specific Actions (NSM Procedure) on page 169
Configuring Service Filters (NSM Procedure) on page 170
Configuring Simple Filters (NSM Procedure) on page 171
You can configure a firewall filter for inet family type.
To configure the firewall filter in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Firewall > Family > Inet.
3.
Select Filter.
4.
Add or modify settings as specified in Table 81 on page 167.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Table 81: Firewall Filter Configuration Details
Task
Configure a firewall filter to
filter IPv4 packets.
Configure accounting for
firewall filters.
Your Action
1.
Expand Inet.
2. Click Filter next to Inet.
3. Click Add new entry next to Filter.
4. Expand Filter.
5. In the name box, enter the name that identifies the filter.
6. In the Comment box, enter the comment.
7. Select the Interface Specific check box to configure
interface-specific names for firewall counters.
1.
Click Accounting Profile next to filter.
2. Click Add new entry next to Accounting Profile.
3. In the New accounting-profile window, enter the name to be
assigned to the accounting profile.
Chapter 15: Configuring Firewall
167
Advertisement
Table of Contents
