Table of Contents
Advertisement
M-series and MX-series Devices
352
OK—Saves the changes.
Cancel—Cancels the modifications.
Table 200: RSVP Configuration Details
Task
Configure RSVP.
Configure the optimization
interval for fast reroute
paths.
Configure RSVP graceful
restart.
Your Action
1.
Expand RSVP.
2. In the Comment box, enter the comment.
3. Select the Disable check box to explicitly disable RSVP or RSVP
graceful restart.
4. Select the No-P2mp-Sublsp check box to reject Resv messages
which include the S2L_SUB_LSP object.
5. From the Refresh Time list, select the refresh time.
Range: 1 through 255
Default: 3
6. From the Keep Multiplier list, select the keep multiplier value.
Range: 1 through 65,535
Default: 30 seconds
7. From the Graceful Deletion-Timeout list, select the time before
completing graceful deletion of signaling.
Range: 1 through 300 seconds
Default: 30 seconds
1.
Expand RSVP.
2. Click Fast Reroute next to RSVP.
3. In the Comment box, enter the comment for the fast reroute.
4. From the Optimize Timer list, select the number of seconds
between fast reroute detour Label-Switched Paths (LSP).
Range: 0 through 65,535 seconds
Default: 0 (disabled)
1.
Expand RSVP.
2. In the Comment box, enter the comment for the filename.
3. Select the Disable check box to explicitly disable RSVP or RSVP
graceful restart.
4. Select the Helper Disable check box to Disable RSVP graceful
restart helper mode.
5. From the Maximum Helper Restart Time list, select the
maximum length of time the router waits between when it
discovers that a neighboring router has gone down and when
it declares the neighbor down.
Range: 1 through 1800 seconds
Default: 20 seconds
6. From the Maximum Helper Recovery Time list, select the
maximum length of time the router stores the state of
neighboring routers when they undergo a graceful restart.
Range: 1 through 3600 seconds
Default: 0 (disabled)
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
