Table of Contents
Advertisement
M-series and MX-series Devices
480
Table 287: Hanging Termination Detection Configuration Details
Task
Configure hanging
termination detection
Configuring Inactivity Timer (NSM Procedure)
You can configure the inactivity timer package, which allows the BGF to use message
inactivity to detect that its active gateway controller has failed using this option.
To configure Inactivity Timer in NSM:
In the navigation tree select Device Manager > Devices.
1.
In the Devices list, double-click the device to select it.
2.
In the Configuration tab, expand Services > Pgcp.
3.
Select Gateway.
4.
Add or modify the settings as specified in Table 288 on page 481.
5.
Click one:
6.
OK—To save the changes.
Cancel—To cancel the modifications.
Your Action
1.
Click Add new entry next to Gateway.
2. Click H248 Properties next to gateway.
3. Expand H248 Properties.
4. Click Hanging Termination Detection next to H248 Properties.
5. In the Comment box, enter the comment.
6. From the Timerx list, select the number of seconds between
the last message exchanged for this termination and when the
BGF sends a notification to the gateway controller.
Range: 0 through 2,147,480
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
