Table 140: Ldp Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

Copyright © 2010, Juniper Networks, Inc.

Table 140: LDP Configuration Details

Task
Configure LDP.
Configure the prefixes
advertised into LDP from the
routing table.
Your Action
1. In the Comment box, enter the comment.
2. From the Preference list, select the route preference level for
LDP routes.
Range: 0 through 4,294,967,295
3. Select the No Forwarding check box to omit the Ingress routes
from the inet.o routing table.
4. Select the L2 Smart Policy check box to prevent LDP from
exporting IPv6 FECs over sessions with layer 2 neighbors.
5. Select the Track IGP Metric check box to cause the IGP route
metric to be used for the LDP routes instead of the default LDP
route metric.
6. Select the Strict Targeted Hellos check box to prevent LDP
sessions from being established with remote neighbors that
have not been specifically configured.
7. Select one of the following:
deaggregate—To control forwarding equivalence class
(FEC) deaggregation on the router.
no-deaggregate—To control forwarding equivalence class
(FEC) aggregation on the router.
8. Select the Explicit Null check box to advertise label 0 to the
egress router of a label-switched path (LSP).
9. From the Label Withdrawal Delay list, select the number of
seconds to wait before withdrawing labels for the LDP LSPs.
Default: 60 seconds
Range: 0 through 120 seconds
10. From the Keep Alive Interval list, select a Keep Alive value.
Range: 1 through 65,535 seconds
Default: 10 seconds
11. From the Keep Alive Timeout list, select a Keep Alive Timeout
value.
Range: 1 through 65,535 seconds
Default: 30 seconds
1. Expand LDP.
2. Click Egress Policy next to LDP.
3. Click Add after selecting a policy member from the Non
member list to add it to the Members list.
4. Click Remove after selecting a policy from the Members list
to remove it from the Members list.
5. Click Add All to add all the Non members to the Members list.
6. Click Remove All to remove all the members from the Members
list.
Chapter 20: Configuring Protocols
267