Configuring Ike (Nsm Procedure); Table 234: Forwarding Options Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

Table 234: Forwarding Options Configuration Details

Option Function
Family > Inet6
Comment Supplies a descriptive comment for the IPv6 traffic.
Mode Specifies the IPv6 traffic forwarding mode.
Family > Iso
Comment Supplies a descriptive comment for the Intermediate
System-to-Intermediate System (IS-IS) protocol
traffic.
Mode Specifies the iso forwarding mode.
Family > Mpls
Comment Supplies a descriptive comment for the MPLS.
Mode Specifies the MPLS forwarding mode.
Related
Documentation

Configuring IKE (NSM Procedure)

Copyright © 2010, Juniper Networks, Inc.
Cancel—Cancels the modifications.
Apply—Applies the forwarding options.
Configuring Certificates (NSM Procedure) on page 390
Configuring the Firewall Authentication (NSM Procedure) on page 392
Configuring a Flow (NSM Procedure) on page 393
The Internet Key Exchange (IKE) feature allows you to configure gateway, policy, proposal,
respond to bad SPI, and traceoptions.
To configure the IKE feature:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure IKE options.
Click the Configuration tab. In the configuration tree, select Security > Ike.
3.
Enter a comment in the IKE workspace that describes the IKE.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Chapter 22: Configuring Security
Your Action
(Optional) Enter a comment.
Select the forwarding mode from the list.
(Optional) Enter a comment.
Select the forwarding mode from the list.
(Optional) Enter a comment.
Select the forwarding mode from the list.
401