Table of Contents
Advertisement
Copyright © 2010, Juniper Networks, Inc.
Configuring RIPng Neighbor Properties
Configuring RIPng Neighbor Properties (NSM Procedure) on page 343
Applying Policies to RIPng Routes Imported from Neighbors (NSM
Procedure) on page 343
Configuring RIPng Update Messages (NSM Procedure) on page 344
Enable or Disable Sending of Update Messages (NSM Procedure) on page 345
Configuring RIPng Neighbor Properties (NSM Procedure)
To define neighbor-specific properties use the Neighbor option.
To configure neighbor specific parameters for RIPng in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Protocols.
3.
Select Ripng.
4.
Add or modify settings as specified in Table 191 on page 343.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Table 191: Neighbor Properties Configuration Details
Task
Define neighbor-specific
properties.
Applying Policies to RIPng Routes Imported from Neighbors (NSM Procedure)
To filter routes being imported by the local routing device from its neighbors, use the
Import option and list the names of one or more policies to be evaluated. If you specify
more than one policy, they are evaluated in order (first to last) and the first matching
policy is applied to the route. If no match is found, the local routing device does not import
any routes.
To configure neighbor specific parameters for RIPng in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Your Action
1.
Click Neighbor next to Group.
2. In the Name box, enter the name of an interface over which a
routing device communicates to its neighbors.
3. In the Comment box, enter the comment.
4. From the Route Timeout list, select the estimated time to wait
before making updates to the routing table.
5. From the Update Interval list, select the estimated time to
wait before making updates to the routing table.
6. From the Metric In list, select the metric value.
Chapter 20: Configuring Protocols
343
Advertisement
Table of Contents
