Table of Contents
Advertisement
Configuring Traceoptions (NSM Procedure)
Copyright © 2010, Juniper Networks, Inc.
Table 299: Session Mirroring Configuration Details
Task
Configure session mirroring.
You can configure Packet Gateway Control Protocol (PGCP) trace options using the
traceoptions option.
To configure traceoptions in NSM:
In the navigation tree select Device Manager > Devices.
1.
In the Devices list, double-click the device to select it.
2.
In the Configuration tab, expand Services > Pgcp.
3.
Select Traceoptions.
4.
Add or modify the settings as specified in Table 300 on page 492.
5.
Click one:
6.
OK—To save the changes.
Cancel—To cancel the modifications.
Your Action
1.
In the Comment box, enter the comment.
2. Select the Disable Session Mirroring check box to disable
session mirroring on the BGF.
3. Expand Session Mirroring.
4. Click Delivery Function next to Session Mirroring.
5. Click Add new entry next to Delivery Function.
6. In the Name box, enter the name of the delivery function that
receives the session mirroring information.
7. In the Comment box, enter the comment.
8. In the Destination Address box, enter the address of the server
to which the BGF sends session-mirroring information.
9. From the Destination Port list, select the port on the delivery
function server that receives session-mirroring information.
Range: 0 through 65535
10. In the Network Operator Id box, enter the network operator ID.
The ID can be up to five characters.
11. In the Source Address box, enter the address of the interface
on which the BGF sends session-mirroring data to the delivery
function.
12. From the Source Port list, select the port on which the BGF
sends session-mirroring data to the delivery function.
Range: 0 through 65,535
13. Expand delivery-function.
14. Click Memory Management next to delivery-function.
15. In the Comment box, enter the comment.
16. From the Operational Mode list, select the operational mode.
Chapter 23: Configuring Services
491
Advertisement
Table of Contents
