Configuring A Port For A Dhcp Or Bootp Relay Agent - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

Configuring a Port for a DHCP or BOOTP Relay Agent

Copyright © 2010, Juniper Networks, Inc.
You can a configure port for a DHCP or BOOTP relay agent using this option.
To configure port for a DHCP or BOOTP relay agent in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Forwarding Options >
3.
Helpers.
Select Port.
4.
Add or modify settings as specified in Table 102 on page 204.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Chapter 16: Configuring Forwarding Options
203