Table 206: Flow Route Fields - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

Table 206: Flow Route Fields

Option
Comment
Route
Name
Comment
Match
Then
Copyright © 2010, Juniper Networks, Inc.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See the Updating
Devices section in the Network and Security Manager Administration Guide for
more information.
Function
Specifies the comment for the flow
route.
Specifies the name of the flow route.
Specifies the comment for the flow
route.
Specifies the conditions that the packet
must match for the packet to be
included in flow route. Match conditions
are:
Destination Port
DSCP
Fragment
Icmp Code
Icmp Type
Packet Length
Port
Protocol
Source Port
Tcp Flag
Enables you to specify the action to take
if the packet matches the conditions you
have configured in the flow route.
Chapter 21: Configuring Routing Options
Your Action
Enter a comment.
1. Expand the Flow tree and select
Route .
2. Click the New button or select a flow
route and click the Edit button.
3. Enter the flow route name.
1. Expand the tree and select
Flow
.
Route
2. Click the New button or select a flow
route and click the Edit button.
3. Enter the comment for the flow
route.
1. Expand the Route tree and select
.
Match
2. Enter a comment for
Comment
destination address for
Destination
and a source address for
Source
3. Configure the match conditions.
1. Expand the tree and select
Route
.
Then
2. Configure the then conditions for the
packet.
, a
,
.
367