Configuring A Destination (Nsm Procedure); Table 250: Traceoptions Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices

Configuring a Destination (NSM Procedure)

Table 250: Traceoptions Configuration Details

Option Function
Destination > General
Comment Supplies a descriptive comment for the destination.
Destination > Pool > General
Name Specifies the name of the destination pool.
Comment Supplies a descriptive comment for the destination
pool.
420
Enter a comment in the NAT workspace that describes the NAT.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the NAT settings.
You can now configure the following options:
Configuring a Destination (NSM Procedure) on page 420
1.
Configuring the Destination Nat (NSM Procedure) on page 421
2.
Configuring the Interface (NSM Procedure) on page 422
3.
Configuring a Proxy Address Resolution Protocol (NSM Procedure) on page 424
4.
5. Configuring a Source (NSM Procedure) on page 425
Configuring Traceoptions (NSM Procedure) on page 428
6.
To configure destination:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure the destination.
Click the Configuration tab. In the configuration tree, select Security > Nat >
3.
Destination.
Configure the options as specified in Table 250 on page 420.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the destination parameters.
Your Action
(Optional) Enter a comment.
Enter a name.
(Optional) Enter a comment.
Copyright © 2010, Juniper Networks, Inc.