Configuring Label Distribution Protocol (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices

Configuring Label Distribution Protocol (NSM Procedure)

266
The Label Distribution Protocol (LDP) is a protocol for distributing labels in
non-traffic-engineered applications. LDP allows routers to establish label-switched
paths (LSPs) through a network by mapping network-layer routing information directly
to data link layer-switched paths.
To configure LDP in NSM:
In the navigation tree select Device Manager > Devices.
1.
In the Devices list, double-click the device to select it.
2.
In the Configuration tab, expand Protocols > LDP.
3.
Add or modify the settings as specified in Table 140 on page 267.
4.
Click one:
5.
OK — To save the changes
Cancel — To cancel the modifications
Copyright © 2010, Juniper Networks, Inc.