Configuring An As Path Group In A Bgp Routing Policy (Nsm Procedure); Table 125: As Path Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices

Table 125: AS Path Configuration Details

Option
Name
Comment
Path

Configuring an AS Path Group in a BGP Routing Policy (NSM Procedure)

244
Cancel—To cancel the modifications.
Apply — To apply the protocol settings.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See the Updating
Devices section in the Network and Security Manager Administration Guide for
more information.
Function
Specifies the name of the AS path.
Specifies the comment for the AS path.
Specifies the AS path (as an AS number)
to be included in the routing policy.
Autonomous System (AS) path group consists of multiple AS paths. You can define
match conditions based on the AS path groups. You can create named AS paths under
an AS path group and then include the AS path group in a routing policy.
To configure an AS path group for a BGP routing policy in NSM:
In the navigation tree, select Device Manager > Devices.
1.
In the Devices list, double-click the device to select it.
2.
Click the Configuration tab.
3.
In the configuration tree, expand Policy Options.
4.
Select As Path Group.
5.
Add or modify the parameters as specified in Table 126 on page 245.
6.
Click one:
7.
OK—To save the changes.
Cancel—To cancel the modifications.
Apply — To apply the protocol settings.
Your Action
Enter a name.
Enters a comment.
Enter an AS path.
Copyright © 2010, Juniper Networks, Inc.