Table 133: Bgp Configuration Fields - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

Table 133: BGP Configuration Fields

Field
General
Path Selection
Traceoptions
Metric Out
Copyright © 2010, Juniper Networks, Inc.
In the navigation tree select
1.
list.
In the configuration tree, expand
2.
Select .
3. BGP
Add/Modify the parameters under the respective tabs as specified in Table 133 on
4.
page 255.
Click one:
5.
OK—To save the changes.
Cancel—To cancel the modifications.
Apply — To apply the protocol settings.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See Updating
Devices for more information.
Function
The general parameters to be set up for
applying BGP.
Enables you to specify the path selection
criteria.
Defines trace options for IGMP snooping.
Enables you to specify the metric value
to add to the routes transmitted to the
neighbor.
Device Manager > Devices
Protocols .
Your Action
1. Expand the
2. Select
3. Specify the general parameters like
comment, description, local address,
hold time, etc.
1. Expand the
2. Select
tab.
3. Set up the path selection parameters
and med plus IGP.
1. Expand the
2. Select
tab.
3. Set up the file and flag parameters.
1. Expand the
2. Select
3. Set up the metric value and minimum
IGP.
Chapter 20: Configuring Protocols
and select the device from the
tree.
Protocol
and select tab.
BGP General
tree.
Protocol
and select
BGP Path Selection
tree.
Protocol
BGP and select Traceoptions
tree.
Protocol
and select tab.
BGP Metric Out
255