About This Guide; Objectives; Audience; Documentation Conventions - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

About This Guide

Objectives

Audience

Documentation Conventions

Copyright © 2010, Juniper Networks, Inc.
Objectives on page xxxi
Audience on page xxxi
Documentation Conventions on page xxxi
Documentation on page xxxiii
Requesting Technical Support on page xxxiv
Juniper Networks Network and Security Manager (NSM) is a software application that
centralizes control and management of your Juniper Networks devices. With NSM, Juniper
Networks delivers integrated, policy-based security and network management for all
devices.
M-series and MX-series devices are routers that run JUNOS software using the
command-line interface (CLI) for installation and configuration.
This guide provides the information you need to understand, configure, and maintain an
M-series or MX-series device using NSM. This guide explains how to use basic NSM
functionality, including adding new devices, deploying new device configurations, updating
device firmware, and monitoring the status of your M-series or MX-series device. Use this
guide in conjunction with the NSM Online Help, which provides step-by-step instructions
that complement the information in this guide.
NOTE: If the information in the latest NSM Release Notes differs from the
information in this guide, follow the NSM Release Notes.
This guide is for the system administrator responsible for configuring the M-series and
MX-series devices.
The sample screens used throughout this guide are representations of the screens that
appear when you install and configure the NSM software. The actual screens may differ.
xxxi