Configuring Enable Service (Nsm Procedure); Table 313: Enable Service Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices

Table 313: Enable Service Configuration Details

Option Function
Name Specifies the interface name.
Comment Specifies the comment for the interface.
508
To configure home agent feature:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure the home agent feature.
Click the Configuration tab. In the configuration tree, select Services > Mobile Ip >
3.
Home Agent.
Enter a comment in the Home Agent workspace that describes the home agent.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the home agent options.
You can now configure the following options:
Configuring Enable Service (NSM Procedure) on page 508
Configuring Pool Match Order (NSM Procedure) on page 509
Configuring the Virtual Network (NSM Procedure) on page 509

Configuring Enable Service (NSM Procedure)

This section provides information on configuring the enable service for home agent.
To configure the enable service mechanism:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure the enable service mechanism.
Click the Configuration tab. In the configuration tree, select Services > Mobile Ip >
3.
Home Agent > Enable Service.
Add or modify settings as specified in Table 313 on page 508.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the enable service options.
Your Action
Enter the interface name. Value: gigabit, fast ethernet
or a 10-gigabit ethernet interface.
Enter a comment.
Copyright © 2010, Juniper Networks, Inc.