Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual page 489

Copyright © 2010, Juniper Networks, Inc.
Table 270: CoS Configuration Details (continued)
Task
Specify the rule the router
uses when applying this
service.
Your Action
1. Click Rule next to CoS.
2. Click Add new entry next to rule.
3. In the Name box, enter the rule the router uses when applying
this service.
4. In the Comment box, enter the comment.
5. From the Match Direction list, select the direction in which
the rule match is applied.
input—Match on input to interface.
output—Match on output from interface.
input–output—Match on input to or output from interface.
6. Expand rule.
7. Click Term next to rule.
8. Click Add new entry next to Term.
9. In the Name box, enter the identifier for the term.
10. In the Comment box, enter the comment.
11. Expand term.
12. Click From next to term.
13. In the Comment box, enter the comment.
14. Expand From.
15. From the listed match conditions, select the ones that are
applicable for CoS.
The match conditions listed are Application Sets, Applications,
Destination Address, Destination Address Range, Destination
Prefix List, Source Address, Source Address Range, and Source
Prefix List.
16. Expand Then.
17. Click Reflexive next to Then.
18. Select one of the following:
reflexive—To apply the equivalent opposing CoS action to
flows in the opposite direction.
reverse—To define the CoS behavior for flows in the reverse
direction.
a. In the Comment box, enter the comment.
b. In the Dscp box, enter the DSCP mapping that is applied
to the packets.
c. In the Forwarding Class, enter the forwarding class to
which packets are assigned
d. From the Application Profile list, select the identifier for
the application profile.
e. Select the Syslog check box to enable system logging.
Chapter 23: Configuring Services
453