Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual page 265

Copyright © 2010, Juniper Networks, Inc.
Table 117: Inet6 Family Configuration Details (continued)
Task
Specify the bandwidth
threshold for VRRP.
Configure input filter.
Your Action
1. Click Bandwidth Threshold next to interface.
2. Click Add new entry next to Bandwidth Threshold.
3. In the Name box, enter the interface name.
4. In the Comment box, enter the comment.
5. From the Priority Cost list, select the VRRP router's priority
cost for becoming the master default router. The router with
the highest priority within the group becomes the master.
Range: 1 through 254
6. Click Route next to Track.
7. In the Route_address box, enter the address.
8. In the Routing Instances box, enter the routing instance in
which the route is to be tracked.
9. From the Priority Cost list, select the VRRP router's priority
cost for becoming the master default router. The router with
the highest priority within the group becomes the master.
10. Click Virtual Address next to vrrp-group.
11. Select one of the following:
virtual-address—To configure the addresses of the virtual
routers in a Virtual Router Redundancy Protocol (VRRP)
IPv4 group. You can configure up to eight addresses.
a. Click Add new entry and in the New virtual-address
window, enter the addresses of one or more virtual
routers.
virtual-inet6-address—To configure the addresses of the
virtual routers in a Virtual Router Redundancy Protocol
(VRRP) IPv6 group. You can configure up to eight addresses.
a. Click Add new entry and in the New
virtual-inet6-address window, enter the addresses of
one or more virtual routers.
1. Click Input next to Filter.
2. Select one of the following:
Select input to configure name of one filter to evaluate
when packets are received on the interface. Enter the input
filter name.
Select input-list to apply a group of filters to evaluate when
packets are received on an interface.
a. Click Add new entry next to input-list.
b. In the New input-list window, enter the filter names.
Up to 16 filters can be included in a filter input list.
Chapter 17: Configuring Interfaces
229