Configuring Operations For Extended Dhcp Relay Agent Processes; Procedure); Table 96: Sever Group Configuration Details; Table 97: Dhcp Relay Traceoptions Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices
Configuring Operations for Extended DHCP Relay Agent Processes (NSM Procedure)
194

Table 96: Sever Group Configuration Details

Task
Specify the name of a group
of DHCP server addresses
for use by the extended
DHCP relay agent.
You can configure tracing operations for extended DHCP relay agent processes.
To configure tracing operations for DHCP relay agent in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Forwarding Options >
3.
DHCP Relay.
Select Traceoptions.
4.
Add or modify settings as specified in Table 97 on page 194.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.

Table 97: DHCP Relay Traceoptions Configuration Details

Task
Configure tracing operations
for extended DHCP relay
agent processes.
Your Action
1. Expand Server Group.
2. In the Comment box, enter the comment for the server group.
3. Click Server Group next to Server Group.
4. Click Add new entry next to Server Group.
5. Expand Server-Group.
6. In the Name box, enter the name of the group of DHCP server
addresses.
7. In the Comment box, enter the comment for the server group.
8. Click Address next to Server-Group.
9. Click Add new entry next to Address.
10. In the Name box, enter the IP address of the DHCP server
belonging to this named server group. You can configure a
maximum of five IP addresses per named server group.
Your Action
1. In the Comment box, enter the comment for the traceoptions.
2. Select the No Remote Trace check box to disable remote
tracing globally or for a specific tracing operation.
Copyright © 2010, Juniper Networks, Inc.