Configuring Protocol Family Information for the Logical Interface (NSM Procedure)
Copyright © 2010, Juniper Networks, Inc.
Click the Configuration tab. In the configuration tree, expand Interfaces.
3.
Select Interface.
4.
Add or modify settings as specified in Table 114 on page 217.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Table 114: Epd Threshold Configuration Details
Task
Define the EPD threshold on
a virtual circuit (VC).
You can configure the family information for the logical interface for different protocols
using the following options:
1.
Configuring Protocol Family (Ccc) Information for the Logical Interface (NSM
Procedure) on page 217
2.
Configuring Protocol Family (Inet) Information for the Logical Interface (NSM
Procedure) on page 219
Configuring Protocol Family (Inet6) Information for the Logical Interface (NSM
3.
Procedure) on page 225
Configuring Protocol Family (ISO) Information for the Logical Interface (NSM
4.
Procedure) on page 231
Configuring Protocol Family (MPLS) Information for the Logical Interface (NSM
5.
Procedure) on page 232
Configuring Protocol Family (TCC) Information for the Logical Interface (NSM
6.
Procedure) on page 234
Configuring Protocol Family (Ccc) Information for the Logical Interface (NSM
Procedure)
To configure ccc family information in NSM:
Your Action
1.
Click Add Interface next to Interface.
2. In the Add Interface Dialog box, enter the interface name.
3. Click Unit next to interface.
4. Click Add new entry next to Unit.
5. Click Epd Threshold next to Unit.
6. In the Comment box, enter the comment.
7. In the Epd Threshold plp0 box, enter the early packet discard
threshold value.
8. In the Plp1 box, enter the maximum number of cells.
Range: For 1-port and 2-port OC12 interfaces, 1 through
425,984 cells
Chapter 17: Configuring Interfaces
217