Table of Contents
Advertisement
Table 214: Configuring Options Fields
Option
Comment
Mark
Syslog
Configuring Routing Tables (NSM Procedure)
Copyright © 2010, Juniper Networks, Inc.
Function
Specifies the comment for the message
option.
Specifies the mark for the option.
Enables you to configure the generation
of system log messages for a particular
severity level and all higher levels.
This feature enables you to configure routing tables. You can also configure the static,
martians, aggregate, maximum paths, maximum prefixes, multipath, or generated routes
to the routing table. If you are not adding any of those routes, then the creation of the
routing table is optional. The JUNOS software uses its default routing tables, which are
for IPv4 unicast routes,
inet.0
forwarding cache, and
inet.3
To configure a routing table in NSM:
In the navigation tree, select
1.
In the
list, double-click the device to select it.
2.
Devices
Click the
Configuration
3.
In the configuration tree, expand
4.
Select
.
Rib
5.
Add or modify the parameters as specified in Table 215 on page 382.
6.
Click one:
7.
OK—To save the changes.
Cancel—To cancel the modifications.
Apply—To apply the routing option settings.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See the Updating
Devices section in the Network and Security Manager Administration Guide for
more information.
Your Action
Enter the comment.
Enter the mark value or select from the
list.
1.
2. Select the severity levels for system
for IPv6 unicast routes,
inet6.0
for IPv4 MPLS.
Device Manager > Devices
tab.
.
Routing Options
Chapter 21: Configuring Routing Options
Expand the
tree and select
Options
.
Syslog
log messages.
for the IPv4 multicast
inet.1
.
381
Advertisement
Table of Contents
