Configuring Forwarding Table (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices
Table 206: Flow Route Fields (continued)
Option
Validation
Comment
Traceoptions

Configuring Forwarding Table (NSM Procedure)

368
Function
Specifies a comment for the validation
procedure. Flow routes are installed into
the flow routing table only if they have
been validated using the validation
procedure.
Enables you to define tracing operations
that track all routing protocol
functionality in the device and specify
that tracing results be saved in a log file.
You can configure the tracing flag, filter,
and the tracing policy.
A forwarding table contains the routes actually used to forward packets through the
device to their next-hop destination. This feature enables you to configure forwarding
table in NSM.
To configure forwarding table in NSM:
In the navigation tree, select
1.
In the list, double click the device to select it.
Devices
2.
Click the Configuration
3.
In the configuration tree, expand
4.
Select Forwarding Table
5.
Add or modify the parameters as specified in Table 207 on page 369.
6.
Click one:
7.
OK—To save the changes.
Cancel—To cancel the modifications.
Apply—To apply the routing option settings.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See the Updating
Devices section in the Network and Security Manager Administration Guide for
more information.
Your Action
1.
2. Enter the comment for the validation
1.
2. Expand the
Device Manager > Devices
tab.
.
Routing Options
.
Expand the Flow tree and select
.
Validation
procedure.
Expand the tree and select
Validation
.
Traceoptions
tree and
Traceoptions
configure the file and flag
parameters, and the tracing policy.
.
Copyright © 2010, Juniper Networks, Inc.