Table of Contents
Advertisement
Table 250: Traceoptions Configuration Details (continued)
Option
Function
Destination > Pool > Routing Instance
Comment
Supplies a descriptive comment for the destination
pool.
Ri Name
Specifies the routing instance (RI) name.
Destination > Pool > Address > IP Address
Comment
Supplies a descriptive comment for the destination
IP address.
IP Address
Specifies the IP address or address range of the
destination pool.
Destination > Pool > Address > To Range/Port
None
Specifies that neither the destination address nor
the port option is selected.
To Address
Specifies the upper limit of the address range.
port
Specifies the port.
Configuring the Destination Nat (NSM Procedure)
Copyright © 2010, Juniper Networks, Inc.
To configure the destination NAT:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure the destination NAT.
Click the Configuration tab. In the configuration tree, select Security > Nat >
3.
Destination Nat.
Add or modify settings as specified in Table 251 on page 422.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the destination NAT settings.
Chapter 22: Configuring Security
Your Action
(Optional) Enter a comment.
Select the Ri Name from the list..
(Optional) Enter a comment.
Enter the IP address or an address range.
Select the option.
Select the option and enter the following:
Comment—A descriptive comment about
the destination address.
To Address—The upper limit of the address
range.
Select the option and set the port. Range: 0 -
65535.
421
Advertisement
Table of Contents
