M-series and MX-series Devices
272
Table 140: LDP Configuration Details (continued)
Task
Configure route and
next-hop properties in the
event of a BFD session
failure event on an LDP LSP.
Your Action
1.
Click Failure Action next to Bfd Liveness Detection.
2. In the Comment box, enter the comment.
3. Select one of the following:
remove-route—To remove LDP route from the ribs
remove-nexthop—To remove LDP nexthop from the route
4. Click Transmit Interval next to Bfd Liveness Detection.
5. In the Comment box, enter the comment.
6. From the Minimum Interval list, select the minimum transmit
and receive interval.
Range: 1 through 255,000
7. From the Threshold list, select the time the BFD session must
remain up before state change notification is sent.
Range: 1 through 4294967295
Copyright © 2010, Juniper Networks, Inc.