Configuring Access Address Pools (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices
Related
Documentation

Configuring Access Address Pools (NSM Procedure)

52
Table 8: Address Assignment Configuration Details (continued)
Task
Configure a static binding for
the specified client.
Configure a named range of
IPv4 addresses or IPv6
prefixes, used within an
address-assignment pool.
Configuring Access Address Pools (NSM Procedure) on page 52
Configuring Access Group Profile (NSM Procedure) on page 53
With an address pool, you configure an address or address range. When you define an
address pool for a client, the layer2 tunneling protocol network server (LNS) allocates
IP addresses for clients from an address pool.
To configure access address pools in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Access.
3.
Select Address Pool.
4.
Add or modify settings as specified in Table 9 on page 53.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Your Action
1. Click Host next to Inet.
2. Click Add new entry next to Host.
3. In the Name box, enter the name of the client.
4. In the Comment box, enter the comment.
5. In the Hardware Address box, enter the MAC address of the
client
6. In the IP Address box, enter the IP version 4 (IPv4) address.
1. Click Range next to Inet.
2. Click Add new entry next to Range.
3. In the Name box, enter the name assigned to the range of IPv4
addresses or IPv6 prefixes.
4. In the Comment box, enter the comment.
5. In the Low box, enter the lower limit of an address range or
IPv6 prefix range.
6. In the High box, enter the upper limit of an address range or
IPv6 prefix range.
Copyright © 2010, Juniper Networks, Inc.