Configuring Notification Behavior (Nsm Procedure); Table 288: Inactivity Timer Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

Copyright © 2010, Juniper Networks, Inc.

Table 288: Inactivity Timer Configuration Details

Task
Configure the inactivity
timeout event.
Configure maximum
inactivity time.

Configuring Notification Behavior (NSM Procedure)

You can configure the default frequency for regulated media inactivity notifications sent
by the BGF using the Notification Behavior option.
To configure notification behavior in NSM:
In the navigation tree select Device Manager > Devices.
1.
In the Devices list, double-click the device to select it.
2.
In the Configuration tab, expand Services > Pgcp.
3.
Select Gateway.
4.
Add or modify the settings as specified in Table 289 on page 482.
5.
Click one:
6.
OK—To save the changes.
Cancel—To cancel the modifications.
Your Action
1. Click Add new entry next to Gateway.
2. Click H248 Properties next to gateway.
3. Expand H248 Properties.
4. Click Inactivity Timer next to H248 Properties.
5. In the Comment box, enter the comment.
6. Expand Inactivity Timer.
7. Click Inactivity Timeout next to Inactivity Timer.
8. In the Comment box, enter the comment.
9. Select the Detect check box to specify the BGF detects inactivity
timeout events received from the BGF by default.
10. Expand Inactivity Timeout.
1. Click Maximum Inactivity Time next to Inactivity Timeout.
2. In the Comment box, enter the comment.
3. From the Defaultlist, select the default value for the maximum
inactivity time.
Range: 100 through 65,535 (10-millisecond units)
Chapter 23: Configuring Services
481