Table of Contents
Advertisement
Configuring MPLS on Interfaces (NSM Procedure)
Copyright © 2010, Juniper Networks, Inc.
Table 146: Diffserv-Aware Traffic Engineering Configuration Details
Task
Configure DiffServ-aware
traffic engineering.
Specify the traffic
engineering class matrix for
a multiclass label switched
path (LSP) or a
DiffServ-aware traffic
engineering LSP.
To configure MPLS on interfaces in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Protocols.
3.
Select Mpls.
4.
Add or modify settings as specified in Table 147 on page 288.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Your Action
1.
Click Diffserve Te next to Mpls.
2. In the Comment box, enter the comment.
3. In the Per Traffic Class Bandwidth box, enter the bandwidth,
in bits per second.
4. From the Bandwidth Model list, select the bandwidth model
for differentiated services.
extended-mam—The extended maximum allocation model
(MAM) is a bandwidth model based on MAM.
mam—The MAM is defined in RFC 4125, Maximum Allocation
Bandwidth Constraints Model for Diffserv-aware MPLS
Traffic Engineering.
rdm—The Russian dolls bandwidth allocation model (RDM)
is defined in RFC 4127, Russian Dolls Bandwidth Constraints
Model for Diffserv-aware MPLS Traffic Engineering.
1.
Click Te Class Matrix next to Diffserv Te.
2. In the Comment box, enter the comment.
3. For the traffic engineering classes, configure the following:
a. In the Comment box, enter the comment.
b. From the Traffic Class list, select the traffic class for the
traffic engineering class.
c. From the Priority list, select the priority of the class type.
Range: 0 through 7
Chapter 20: Configuring Protocols
287
Advertisement
Table of Contents
