Table 131: Configuring Prefix List Fields - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

Table 131: Configuring Prefix List Fields

Field
Name
Comment
Apply Path
Prefix List Item
Copyright © 2010, Juniper Networks, Inc.
In the navigation tree select Device Manager > Devices and select the device from
1.
the list.
In the configuration tree, expand Policy Options.
2.
Select Prefix List.
3.
Add/Modify the parameters as specified in Table 131 on page 251.
4.
Click one:
5.
OK—To save the changes.
Cancel—To cancel the modifications.
Apply — To apply the protocol settings.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See Updating
Devices section in the Network and Security Manager Administration Guide for
more information.
Function
Specifies the name of the prefix list.
Specifies the comment for the prefix list.
Indicates that the prefix list should
include all IP prefixes pointed to by a
defined path.
Specifies the prefix list item.
Chapter 19: Configuring Policy Options
Your Action
1. Click the New button or select a
prefix list and click Edit button.
2. Select prefix-list.
3. Specify the name.
1. Click the New button or select a
prefix list and click Edit button.
2. Select prefix-list.
3. Specify the comment.
1. Click the New button or select a
prefix list and click Edit button.
2. Select prefix-list.
3. Specify the path.
1. Click the New button or select a
prefix list and click Edit button.
2. Expand prefix-list tree and select
Prefix List Item.
3. Specify the name and comment.
251