Table of Contents
Advertisement
Copyright © 2010, Juniper Networks, Inc.
Table 117: Inet6 Family Configuration Details (continued)
Task
Define one or more service
sets to be applied to an
interface.
Configuring Protocol Family (ISO) Information for the Logical Interface (NSM
Procedure)
To configure iso family information in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Interfaces.
3.
Select Interface.
4.
Add or modify settings as specified in Table 118 on page 232.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Your Action
1.
Click Service next to Inet.
2. In the Comment box, enter the comment.
3. Click Input next to Service.
4. In the Comment box, enter the comment.
5. In the Post Service Filter box, enter the filter to be applied to
traffic after service processing.
6. Expand Input.
7. Click Service Set next to Input.
8. Click Add new entry next to Service Set.
9. From the Name list, select the service set name.
10. In the Comment box, enter the comment.
11. In the Service Filter box, enter the filter name.
12. Click Output next to Service.
13. In the Comment box, enter the comment.
14. Expand Output.
15. Click Service Set next to Output.
16. Click Add new entry next to Service Set.
17. From the Name list, select the service set name.
18. In the Comment box, enter the comment.
19. In the Service Filter box, enter the filter name.
Chapter 17: Configuring Interfaces
231
Advertisement
Table of Contents
