Configuring File (Nsm Procedure); Table 317: Traceoptions Configuration Details; Table 318: File Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices

Table 317: Traceoptions Configuration Details

Option
Comment
No Remote Trace
Level

Table 318: File Configuration Details

Option Function
Comment Specifies the comment for the filename.
Filename Specifies the filename to write the traceoptions.
Size Specifies the maximum size of the trace file.
514
Configure the options as specified in Table 317 on page 514.
4.
Click one:
5.
OK — Saves the changes.
Cancel — Cancels the modifications.
Apply—Applies the traceoptions settings.
Function
Supplies a descriptive comment for the traceoptions.
Disables the remote tracing option.
Specifies the level of debugging output.
You can configure the following options under traceoptions:
Configuring File (NSM Procedure) on page 514
Configuring Flag (NSM Procedure) on page 515

Configuring File (NSM Procedure)

To configure file options:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure the traceoptions file feature.
Click the Configuration tab. In the configuration tree, select Services > Mobile Ip >
3.
Traceoptions > File.
Configure the file options as specified in Table 318 on page 514.
4.
Click one:
5.
OK — Saves the changes.
Cancel — Cancels the modifications.
Apply—Applies the file options.
Your Action
Enter a comment.
Select the No Remote Trace check box.
Select the level.
Your Action
Enter a comment.
Enter a filename.
Enter the maximum file size.
Copyright © 2010, Juniper Networks, Inc.