Table of Contents
Advertisement
Related
Documentation
Setting the Polling Interval For Device Alarm Status
Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
To retrieve the current alarm status in the device, click the Refresh button.
2.
The poll time is derived from the device server time.
About the Realtime Monitor on page 579
Viewing Device Status on page 580
Setting the Polling Interval For Device Alarm Status on page 583
The default polling interval is 900 seconds (15 minutes). To configure polling intervals
for Alarm Status:
From Device Manager>Devices, double-click the device to open it.
1.
The Info tab dialog box is displayed.
Select the Device Admin page to set the polling interval for the device.
2.
The minimum polling interval is 60 seconds. The maximum interval is 2,147,483,647
seconds. You cannot disable polling.
About the Realtime Monitor on page 579
Viewing Device Status on page 580
Viewing Device Monitor Alarm Status on page 582
Chapter 29: Real Time Monitoring of M-series and MX-series
583
Advertisement
Table of Contents
