Configuring Maximum Paths (Nsm Procedure); Table 210: Configuring Martian Address Fields - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices

Table 210: Configuring Martian Address Fields

Option
Address
Comment
Allow
Exact

Configuring Maximum Paths (NSM Procedure)

374
Function
Specifies the martian address or the
destination prefix of a series of martian
addresses that are to be allowed or
disallowed.
Specifies the comment for the martian
address.
Enables you to explicitly allow a subset
of a range of addresses that are to be
disallowed.
Specifies match criteria for the route's
mask length with the martian address.
The criteria are:
Exact
Longer
Orlonger
Upto
Through
Prefix Length Range
You can configure a limit for the number of routes installed in a routing table based upon
the number of route paths in the table.
To configure a maximum paths limit in NSM:
In the navigation tree, select
1.
In the Devices list, double-click the device to select it.
2.
Click the
3. Configuration
In the configuration tree, expand
4.
Select
5. Maximum Paths
Your Action
1.
2. Enter the address.
1.
2. Enter the comment for the martian
1.
2. Select the check box to allow the
3. Clear the check box to disallow the
1.
2. Expand the
3. Enter the match criteria.
Device Manager > Devices
tab.
Routing Options
.
Click the New button or select a
martian address and click the Edit
button.
Click the New button or select a
martian address and click the Edit
button.
address.
Click the New button or select a
martian address and click the Edit
button.
disallowed address. Selecting the
allow option deletes a particular
martian address from the range of
martian addresses.
addresses and mark them as a
martian address.
Click the New button or select a
martian address and click the Edit
button.
tree and select
Martian
.
Exact
.
.
Copyright © 2010, Juniper Networks, Inc.