Table of Contents
Advertisement
M-series and MX-series Devices
Configuring SNMP Trap Groups (NSM Procedure)
Table 330: Configuring SNMP Trap Group Fields
Option
Name
Version
Destination Port
Routing Instance
528
You can create and name a group of one or more types of SNMP traps and then define
which systems receive the group of SNMP traps. The trap group must be configured for
SNMP traps to be sent. The trap group name can be any string and is embedded in the
community name field of the trap. To configure your own trap group port, use the
option. The default destination port is port 162. For each trap group that
Destination Port
you define, specify:
At least one system as the recipient of the SNMP traps in the trap group
The types of traps the trap group can receive
Routing instance used by the trap group
To configure trap groups in NSM:
In the navigation tree, select Device Manager > Devices.
1.
In the Devices list, double-click the device to select it.
2.
Click the Configuration tab.
3.
In the configuration tree, expand SNMP.
4.
Select Trap Group.
5.
Select the Enable Feature check box.
6.
Enter the parameters as specified in Table 330 on page 528.
7.
Click one:
8.
OK—To save the changes.
Cancel—To cancel the modifications.
Apply—To apply the SNMP settings.
Function
Specifies a name for the trap group.
Specifies the version number of the
SNMP trap group.
Specifies the SNMP trap group port
number.
Specifies a routing instance for trap
targets.
Your Action
Enter a name for the trap group.
Select the version number for the SNMP
trap group from the list.
Enter a trap group port number.
Enter the name of the routing instance.
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
