Table of Contents
Advertisement
Copyright © 2010, Juniper Networks, Inc.
Table 154: Lsp Attributes Configuration Details
Task
Define the parameters
signaled during LSP setup.
Configuring BFD for MPLS IPv4 LSPs (NSM Procedure)
You can configure BFD for LSPs that use either LDP or RSVP as the signaling protocol
using the Oam option.
To configure BFD for LSPs in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Protocols > Mpls.
3.
Select Label Switched Path.
4.
Your Action
1.
Click Add new entry next to Label Switched Path.
2. Click Lsp Attributes next to label-switched-path.
3. In the Comment box, enter the comment.
4. From the Signal Bandwidth list, select the type of bandwidth
encoding used on the LSP. The options available for selection
are 10gigether, ds1, ds3, e1, e3, ethernet, fastether, gigether,
stm-1, stm-4, stm-16, stm-64, stm-256, sts-1, vt1-5, or vt2.
5. From the Switching Type list, select the switching method for
the LSP. Select one of the following:
fiber—Fiber switching
lambda—Lambda switching
psc-1—Packet switching
tdm—Time-division multiplexing (TDM) switching
6. From the Encoding Type list, select the encoding type of
payload carried by the LSP. Select one of the following:
ethernet—Ethernet
packet—Packet
pdh—Plesiochronous digital hierarchy (PDH)
sonet-sdh—SONET/SDH
7. From the Gpid list, select the type of payload carried by the
LSP. Select one of the following:
ethernet—Ethernet (GPID value: 33)
hdlc—High-level Data Link Control (HDLC) (GPID value: 44)
ipv4—IP version 4 (GPID value: 0x0800)
pos-no-scrambling-crc-16—for interoperability with other
vendors' equipment (GPID value: 29)
pos-no-scrambling-crc-32—for interoperability with other
vendors' equipment (GPID value: 30)
pos-scrambling-crc-16—for interoperability with other
vendors' equipment (GPID value: 31)
pos-scrambling-crc-32—for interoperability with other
vendors' equipment (GPID value: 32)
ppp—Point-to-Point Protocol (PPP) (GPID value: 50)
Chapter 20: Configuring Protocols
297
Advertisement
Table of Contents
