Configuring File Options (Nsm Procedure); Table 230: Traceoptions Configuration Details; Table 231: File Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices

Table 230: Traceoptions Configuration Details

Option Function
Comment Supplies a descriptive comment for the
traceoptions.
No Remote Trace Disables remote tracing.
Rate Limit Specifies the limit for the incoming rate of trace
messages.

Table 231: File Configuration Details

Option Function
Comment Supplies a descriptive comment for the filename.
Filename Specifies the filename to write the traceoptions.
Size Specifies the maximum size of the trace file.
Files Specifies the maximum number of the trace files.
None Specifies that neither the world-readable nor the
no-world-readable option is enabled.
398
You can now configure the following options:
Configuring File Options (NSM Procedure) on page 398
Configuring Flag Options (NSM Procedure) on page 399
Configuring Packet Filter Options (NSM Procedure) on page 399

Configuring File Options (NSM Procedure)

To configure file options:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure the file options.
Click the Configuration tab. In the configuration tree, select Security > Flow >
3.
Traceoptions > File.
Configure the file options as specified in Table 231 on page 398.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the file settings.
Your Action
(Optional) Enter a comment.
Select the No Remote Trace check box to enable
this feature.
Set the incoming rate for trace messages. Range:
0 - 4294967295.
Your Action
(Optional) Enter a comment.
Enter a filename.
Enter the maximum file size.
Set the maximum number of the trace files.
Range: 2 - 1000.
Select the option.
Copyright © 2010, Juniper Networks, Inc.