Configuring Export Policy (Nsm Procedure); Table 176: Active Source Limit Configuration Details; Table 177: Export Policy Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices

Configuring Export Policy (NSM Procedure)

324

Table 176: Active Source Limit Configuration Details

Task
Configure active source
limit.
To apply policies to source-active messages being exported from the source-active cache
into MSDP, use the Export option.
To configure export policy in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Protocols.
3.
Select Msdp.
4.
Add or modify settings as specified in Table 177 on page 324.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.

Table 177: Export Policy Configuration Details

Task
Apply one or more policies to
routes being exported from
the routing table into MSDP.
Your Action
1. Click Active Source Limit next to Msdp.
2. In the Comment box, enter the comment.
3. From the Maximum list, select the maximum number of active
source messages.
Range: 1 through 1,000,000
Default: 25,000
4. From the Threshold list, select the RED threshold for active
source messages.
Range: 1 through 1,000,000
Default: 24,000
Your Action
1. Click Export Policy next to Msdp.
2. Use the following options to select the policies to export.
Click Add after selecting a policy member from the Non
member list to add it to the Members list.
Click Remove after selecting a policy from the Members
list to remove it from the Members list.
Click Add All to add all the Non members to the Members
list.
Click Remove All to remove all the members from the
Members list.
Copyright © 2010, Juniper Networks, Inc.