M-series and MX-series Devices
Configuring the RADIUS Parameters (NSM Procedure)
68
Table 23: RADIUS Parameter Configuration Details (continued)
Task
Configure the RADIUS client
to use the extended format
for RADIUS attribute 5
(NAS-Port) and specify the
width of the fields in the
NAS-Port attribute.
You can specify the options used by the RADIUS authentication and accounting servers.
To configure the RADIUS parameters in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Access.
3.
Select Profile.
4.
Add or modify settings as specified in Table 24 on page 68.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
NOTE: To create a profile, the device should be in the in-device policy mode.
Table 24: RADIUS Parameters Configuration Details
Task
Configure the RADIUS
parameters.
Your Action
1.
Click Nas Port Extended Format next to Options.
2. In the Comment box, enter the comment.
3. From the Slot Width list, select the number of bits in the slot
field.
4. From the Adapter Width list, select the number of bits in the
adapter field.
5. From the Port Width list, select the number of bits in the port
field.
6. From the Stacked Vlan Width list, select the number of bits
in the SVLAN ID field.
7. From the Vlan Width list, select the number of bits in the VLAN
ID field.
Your Action
1.
Click Add new entry next to Profile.
2. Click Radius Options next to Profile.
3. In the Comment box, enter the comment.
4. From the Revert Interval list, select the amount of time the
router waits after a server has become unreachable.
Default: 600 seconds
Copyright © 2010, Juniper Networks, Inc.