Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual page 186

M-series and MX-series Devices
150
Table 72: Translation Table Configuration Details (continued)
Task
Translate incoming MPLS EXP values to new
values.
Your Action
1. Click To Exp From Exp next to Translation
Table.
2. Click Add new entry next to To Exp From
Exp.
3. In the Name box, enter the MPLS EXP
values.
4. In the Comment box, enter the comment.
5. Click To Code Point next to
to-exp-from-exp.
6. Click Add new entry next to
to-exp-from-exp.
7. From the Name list, select the EXP code
point.
8. In the Comment box, enter the comment.
9. Click From Code Points next to
to-code-point and perform the following:
Add—Adds the selected code points from
the Non member list to the Members list.
Remove—Removes the selected code
points from the Members list.
Add All—Adds all the code points from
the Non-members list to the Members
list.
Remove All—Removes all the code points
from the Members list.
Copyright © 2010, Juniper Networks, Inc.