Table 116: Inet Family Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices
220

Table 116: Inet Family Configuration Details

Task Your Action
Configure Inet 1. Click Add Interface next to Interface.
information.
2. In the Add Interface Dialog box, enter the interface name.
3. Click Unit next to interface.
4. Click Add new entry next to Unit.
5. Click Family next to Unit.
6. Expand Family.
7. Click Inet next to Family.
8. In the Comment box, enter the comment.
9. From the Mac Validate list, select one of the following:
strict—Forwards incoming packets when both the IP source address
and the MAC source address match one of the trusted address tuples.
Drops packets when the MAC address does not match the tuple's MAC
source address, or when IP source address of the incoming packet does
not match any of the trusted IP addresses.
loose—Forwards incoming packets when both the IP source address
and the MAC source address match one of the trusted address tuples.
Drops packets when the IP source address matches one of the trusted
tuples, but the MAC address does not match the MAC address of the
tuple. Continues to forward incoming packets when the source address
of the incoming packet does not match any of the trusted IP addresses.
10. From the Mtu list, select the MTU size.
Range: 0 through 4294967295
11. Select the No Redirects check box to disable the sending of protocol
redirect messages for the entire routing platform.
12. Select the No Arp Learn check box to disable ARP mappings.
13. Select the Primary check box to configure the address to be the primary
address of the protocol on the interface.
Enable IP packet 1. Click Accounting next to Inet.
counters on an
2. In the Comment box, enter the comment.
interface.
3. Select the Destination Class Usage check box to enable packet counters
on an interface that count packets that arrive from specific customers and
are destined for specific prefixes on the provider core router.
4. Click Source Class Usage next to Accounting.
5. In the Comment box, enter the comment.
6. Select the Input check box to configure at least one expected ingress point.
7. Select the Output check box to configure at least one expected egress
point.
Copyright © 2010, Juniper Networks, Inc.