Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual page 202

M-series and MX-series Devices
Related
Documentation
166
Table 80: Ccc Filter Configuration Details (continued)
Task
Define a firewall filter term.
Configuring the Firewall Filter for Bridge Family Type (NSM Procedure) on page 163
Configuring the Firewall Filter for MPLS Family Type (NSM Procedure) on page 176
Configuring the Firewall Filter for VPLS Family Type (NSM Procedure) on page 179
Your Action
1. Click Term next to Accounting Profile.
2. Click Add new entry next to Term.
3. Expand Term.
4. In the Name box, enter the name that identifies the term.
5. In the Comment box, enter the comment for the term.
6. From the Filter list, select the name that identifies the filter.
7. Expand From.
8. In the Comment box, enter the comment.
9. From the listed protocol-independent match conditions, select
the filters defined for the Ccc family type.
The protocol-independent match conditions are Forwarding
Class, Interface Group, Vlan 1p property, Loss Priority, and User
Vlan-1p Priority.
10. Expand Then.
11. In the Comment box, enter the comment for then.
12. In the Count box, enter the number of packets.
13. From the Loss Priority list, set the packet loss priority (PLP)
to low, medium-low, medium-high, or high.
14. In the Forwarding Class box, enter the packet forwarding class
name.
15. Click Accept next to Then.
16. Select one of the following:
—To accept a packet.
Accept
—To discard a packet silently, without sending an
Discard
ICMP message.
—To evaluate the next term in the firewall filter.
Next
17. Click Policer next to Then.
18. Select one of the following:
Policer —To configure a new policer for each filter and select
the policer name.
—To configure a tricolor marking policer,
three-color-policer
a. Expand Three Color Policer.
b. Click Single Rate next to Three Color Policer.
c. Select one of the following:
single-rate—if the named tricolor policer is a
single-rate policer.
two-rate—if the named tricolor policer is a two-rate
policer.
Copyright © 2010, Juniper Networks, Inc.