Configuring Events; Configuring Traceoptions - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices
Table 332: Destination Configuration Details (continued)
Option Function
Single Connection Specifies the attempts that the optimize TCP
connection tries.
Source Address Specifies the source address of the authentication
server.

Configuring Events

Configuring Traceoptions

534
To configure events:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure the events.
Click the Configuration tab. In the configuration tree, select System > Accounting >
3.
Events.
Click + to add a new event.
4.
Select the available event from the list.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the event settings.
The traceoptions feature allows you to configure file and flag options.
To configure traceoptions:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure the traceoptions.
Click the Configuration tab. In the configuration tree, select System > Accounting >
3.
Traceoptions.
Enter a comment for the traceoptions.
4.
Select the No Remote Trace check box to enable remote tracing.
5.
Add or modify settings as specified in Table 333 on page 535.
6.
Click one:
7.
OK—Saves the changes.
Cancel—Cancels the modifications.
Your Action
Enable the Single Connection check box to
enable this feature.
Enter a source address for the authentication
server.
Copyright © 2010, Juniper Networks, Inc.